| 2.1 |
A 1/4" ball-end allen screw
should be pre-installed on the bottom of the lower cam. If it is
not, screw it into the hole opposite the "V" allowing it to
protrude about 1/4". Also check to see that the set screw on the
upper can is securely tightened. |
| 2.2 |
Hold the door in the doorway in
a partially opened position and tilt it downward slightly to
face the floor while sliding the lower shaft into the jamb guard
hole. |
| 2.3 |
Hold the lower cam up
against the upper cam and guide the shaft into the upper
bracket. Seat the lower cam upon the bracket being sure the
screw enters the small slot in the bracket and that the
remaining holes in the cam align with the holes in the bracket. |
| 2.4 |
Secure the cam to the bracket
by inserting and tightening the remaining two ball end screws. |
Home
